Follow along with the video below to see how to install our site as a web app on your home screen.
Catatan: This feature may not be available in some browsers.
Saat ini Anda mengakses IndoForum sebagai tamu, sehingga Anda tidak memiliki akses penuh untuk melihat artikel dan diskusi yang hanya tersedia bagi anggota. Dengan bergabung, Anda akan mendapatkan akses penuh untuk bertanya, mengirim pesan pribadi, mengikuti polling, dan menggunakan fitur-fitur lainnya. Proses pendaftaran sangat cepat, mudah, dan gratis. Silakan daftar dan validasi email Anda untuk mendapatkan akses penuh sebagai anggota. Harap masukkan alamat email yang valid dan periksa kotak masuk Anda setelah mendaftar untuk proses validasi.
TK1 and TK2 are OSPF routers on a point-point link. On this point-to-point
network, OSPF hello packets are addressed to which address?
A. 192.168.0.5
B. 254.255.255.255
C. 223.0.0.1
D. 172.16.0.1
E. 224.0.0.5
F. 127.0.0.1
G. None of the above
Two TestKing routers are connected via a PPP connection. Which of the following
are key characteristics of this PPP connection? (Choose three)
A. PPP can be used over analog circuits
B. PPP encapsulates several routed protocols
C. PPP maps Layer 2 to Layer 3 address
D. PPP provides error correction
E. PPP supports IP only
F. PPP provides encryption services
A network administrator is having trouble with a remote router. The administrator
connects to the router via telnet and types a debug command, but no debug output
appears on the screen. What command should the administrator type to view the
debug output?
A. TestKing1# show debug
B. TestKing1# debug all
C. TestKing1# terminal monitor
D. TestKing1# no debug *
E. TestKing1# enable debug
It has become necessary to configure an existing serial interface to accept a second
Frame Relay virtual circuit. Which of the following procedures are required to
accomplish this task? (Choose three.)
A. Encapsulate the physical interface with multipoint PPP.
B. Configure static Frame Relay map entries for each subinterface network.
C. Disable split horizon to prevent routing loops between the subinterface networks.
D. Remove the IP address from the physical interface.
E. Create the virtual interfaces with the interface command.
F. Configure each subinterface with its own IP address.
You are securing a network for TestKing and want to apply an ACL (access control
list) to an interface of a router. Which one of the following commands would you
use?
A. permit access-list 101 out
B. ip access-group 101 out
C. apply access-list 101 out
D. access-class 101 out
E. ip access-list e0 out
F. None of the above
Which two statements describe the Cisco implementation of VLANs? Select two.
A. VLANs 1002 through 1005 are automatically created and cannot be deleted.
B. VLAN 1 is the default Ethernet VLAN.
C. By default, the switch IP address is in VLAN 1005.
D. CDP advertisments are only sent on VLAN 1002.
What is the purpose of the Cisco VLAN Trunking Protocol?
A. to allow native VLAN information to be carried over a trunk link.
B. To provide a mechanism to dynamically assign VLAN membership to switch ports.
C. To allow traffic to be carried from multiple VLANs over a single link between
switches.
D. To provide a mechanism to dynamically assign VLAN membership to switch ports.
E. To allow for managing to additions, deletions, and changes of VLANs between
switches.
What is the purpose of using the traceroute command?
A. to display the MTU values for each router in a specified network path from a source to
a destination.
B. To map all the devices on a network.
C. To see the path a packet will take when traveling to a specified destination.
D. To display the current TCP/IP configuration values.
E. To see how a device MAC address is mapped to its IP address
What is the purpose of an ARP request message?
A. It creates a session by passing a header with destination Layer 2 address to the
transport layer.
B. It binds the IP address of a host to the network that it is on.
C. It encapsulates the Layer 3 address and then passes the packet to Layer 2.
D. It builds a correlation between an IP address and a MAC address.
E. It provides connectivity and path selection between hosts on a network.
A receiving host computes the checksum on a frame and determines that the frame
is damaged. The frame is then discarded. At which OSI layer did this happen?
A. Application
B. Presentation
C. Session
D. Transport
E. Internet
F. Data Link
G. Physical
Which connection uses the default encapsulation for serial interfaces on Cisco
routers?
A. The serial connection to the Multinational Core
B. The serial connection to the TestKing1 branch office
C. The serial connection to the TestKing2 branch office
D. The serial connection to the TestKing3 branch office
A static map to the TestKing12 location is required. Which command should be
used to create this map?
A. frame-relay map ip 172.30.0.3 344 broadcast
B. frame-relay map ip 172.30.0.3 704 broadcast
C. frame-relay map ip 172.30.0.3 702 broadcast
D. frame-relay map ip 172.30.0.3 196 broadcast
If required, what password should be configured on the router in the TestKing2
branch office to allow a connection to be established with the TestKing1 router?
A. C0nsole
B. No password is required
C. T1net
D. En8ble
E. Scr8
Note: Please refer to the TestKing Communications scenario.
Tess King has opened two Internet Explorer windows on her local PC TestKing6.
She uses them to simultaneously access the local web server TestKingC at the time
to browse WWW documents on the intranet.
What mechanism makes the data to end up in the correct Internet Explorer
window?
A. The OSI application layer tracks the conversations and directs them to the correct
browser.
B. The IP Source addresses of the packets will be used to direct the data to the correct
browser window.
C. The browser track the data by the URL.
D. The TCP port numbers are used to direct the data to the correct application window.
Note: Please refer to the TestKing Communications scenario.
The TestKing6 PC has sent the ARP request, and has now received the ARP reply.
TestKing6 now build a packet that will be sent to TestKingC web server in order to
establish the communication.
What information will be placed in the header of this packet? Select two.
A. The source address will be the IP address of the Fa0/0 interface of Router TestKing2.
B. The source address will be the IP address of the Fa0/0 interface of Switch TestKingB.
C. The source address will be the IP address of PC TestKing6.
D. The destination address will be the IP address of interface Fa0/0 of Router TestKing2.
E. The destination address will be the IP address of interface Fa0/0 of Router TestKingA.
F. The destination address will be the IP address of interface S0/0 of Router TestKing2.
G. The destination address will be the IP address of interface S0/0 of Router TestKingA.
H. The destination address will be the IP address of the TestKing3 web server.
Of the following choices below, only three could be used as WAN encapsulation
methods, as opposed to LAN encapsulation. Which three are they? (Choose three)
A. FDDI
B. HDLC
C. Frame Relay
D. PPP
E. Token Ring
F. Ethernet
G. VTP
TestKing has 25 computers and decides to connect the network to the Internet.
TestKing would like for all of the computers to have access to the Internet at the
same time, but TestKing only has four usable publicly routable IP addresses.
What should be configured on the router so that all computers can connect to the
Internet simultaneously?
A. Static NAT
B. Global NAT
C. Dynamic NAT
D. Static NAT with ACLs
E. Dynamic NAT with overload
Which of the following are characteristics of named access lists? (Choose three)
A. Individual statements in a named access list may be deleted.
B. They require a numbered range from 1000 to 1099.
C. When created, they must be specified as standard or extended.
D. They are created with the ip access-list command.
E. The entire access list must be deleted before editing.
F. They are applied with the ip name-group command.
