• Saat ini Anda mengakses IndoForum sebagai tamu, sehingga Anda tidak memiliki akses penuh untuk melihat artikel dan diskusi yang hanya tersedia bagi anggota. Dengan bergabung, Anda akan mendapatkan akses penuh untuk bertanya, mengirim pesan pribadi, mengikuti polling, dan menggunakan fitur-fitur lainnya. Proses pendaftaran sangat cepat, mudah, dan gratis.
    Silakan daftar dan validasi email Anda untuk mendapatkan akses penuh sebagai anggota. Harap masukkan alamat email yang valid dan periksa kotak masuk Anda setelah mendaftar untuk proses validasi.

Dvd paket kompilasi belajar cisco ccna & ccnp

  • Pembuat thread awal. Pembuat thread awal. ambun1
  • Tanggal Mulai Tanggal Mulai
QUESTION NO: 5

What kind of message does a PING send out to test connectivity?
A. ICMP echo request
B. Information interrupt request
C. Timestamp reply
D. Source quench
E. None of the above

Answer: A
 
QUESTION NO: 21

Router TK1 is being installed. You wish to add this router to your existing OSPF
network. In doing so, you configure the following:

TK1(config)# router ospf 1
TK1(config-router)# network 10.10.10.0 255.255.255.0 area 0
After making this change, you notice that the networks attached to TK1 are not

being learned by the other OSPF routers. What could be the cause of this?

A. The AS is not correctly configured
B. The network subnet mask is incorrectly configured
C. The network wildcard mask is configured incorrectly
D. The network number is not correctly configured
E. The process id is configured incorrectly
F. None of the above

Answer: C
 
QUESTION NO: 3

Router TK1 has just received a packet and needs to route it. What two actions must this router take in order to route incoming packets? (Choose two)

A. Inspect the routing table to select the best path to the destination network addresses.
B. Validate sources of routing information.
C. Inspect the ARP table to verify a legitimate source MAC address for each packet.
D. Identify the destination network address of each packet.
E. Verify the receipt of routed packets by the next hop router.
F. Identify the source network address of each packet.

Answer: A, D
 
QUESTION NO: 1

The TestKing network administrator has issued the "VTP password TESTKING"
command on a Cisco device. What is the purpose of this command?

A. It allows two VTP servers to exists in the same domain, each configured with different passwords
B. It is the password required when promoting a switch from VTP client mode to VTP server mode
C. It is used to access the VTP server to make changes to the VTP configuration
D. It is used to validate the sources of VTP advertisements sent between switches
E. None of the above

Answer: D
 
QUESTION NO: 10

Some of the TestKing routers have been configured with default routes. What are some of the advantages of using default routes? (Choose two)

A. They establish routes that will never go down.
B. The keep routing tables small.
C. They require a great deal of CPU power.
D. The allow connectivity to remote networks that are not in the routing table.
E. They direct traffic from the Internet into corporate networks.

Answer: B, D
 
QUESTION NO: 4

You are given a PC, a router, and a cable. Select the correct combination that will allow you to log into router TK1 locally using a terminal emulation program such as HyperTerminal.
A. Connect the PC's COM port to the router's console port using a straight-through cable.
B. Connect the PC's COM port to the router's console port using a rollover cable.
C. Connect the PC's COM port to the router's Ethernet port using a straight-through cable.
D. Connect the PC's Ethernet port to the router's Ethernet port using a rollover cable.
E. Connect the PC's Ethernet port to the router's Ethernet port using a straight- through cable.
F. None of the above

Answer: B
 
QUESTION NO: 4

An administrator issues the command "ping 127.0.0.1" from the command line
prompt on a PC host named TK1. If an ICMP reply is received, what does this
confirm?

A. PC host TK1 has connectivity up to Layer 5 of the OSI model.
B. PC host TK1 has a default gateway correctly configured.
C. PC host TK1 has connectivity with a local host.
D. PC host TK1 has the TCP/IP protocol stack correctly installed.
E. PC host TK1 has connectivity with a Layer 3 device.
F. None of the above

Answer: D
 
QUESTION NO: 8

Which of the following addresses can be assigned to a host when using a subnet
mask of 255.255.254.0? (Select three)

A. 113.10.4.0
B. 186.54.3.0
C. 175.33.3.255
D. 26.35.2.255
E. 152.135.7.0
F. 17.35.36.0

Answer: B, D, E
 
QUESTION NO: 2

You need subnet a TestKing network segment. How many subnetworks and hosts are available per subnet if you apply a /28 mask to the 210.10.2.0 class C network?

A. 30 networks and 6 hosts.
B. 6 networks and 30 hosts.
C. 8 networks and 32 hosts.
D. 32 networks and 18 hosts.
E. 16 networks and 14 hosts.
F. None of the above

Answer: E
 
QUESTION NO:4

What is the IEEE standard associated with Gigabit Ethernet? (Select two answer choices)

A. 802.11
B. 802.5
C. 802.3ab
D. 802.3ae
E. 802.3z
F. 802.3u

Answer: C, E
 
QUESTION NO: 9

You need to configure the interfaces on a new TestKing router, but first you need to enter the global configuration mode. Which command is used on router TestKing3 to reach this mode?

A. TestKing3# router
B. TestKing3# setup
C. TestKing3# interface
D. TestKing3> enable
E. TestKing3# configure terminal

Answer: E
 
QUESTION NO: 2

You are a systems administrator and you are about to assign static IP addresses to various servers on your network. For the network 192.168.20.24/29 the router is
assigned to the first usable host address, while the last usable host address goes to your Sales server. Which one of the following commands would you enter into the IP properties box of the sales server?

A. IP address: 192.168.20.14 Subnet Mask: 255.255.255.248 Default ateway: 192.168.20.9
B. IP address: 192.168.20.254 Subnet Mask: 255.255.255.0 Default Gateway:
192.168.20.1
C. IP address: 192.168.20.30 Subnet Mask 255.255.255.248 Default Gateway:
192.168.20.25
D. IP address: 192.168.20.30 Subnet Mask 255.255.255.240 Default Gateway:
192.168.20.17
E. IP address: 192.168.20.30 Subnet Mask 255.255.255.240 Default Gateway:
192.168.20.25

Answer: C
 
QUESTION NO: 15

You are the network administrator at TestKing. You need to perform password
recovery on Router TK1. What must you modify in the password recovery process?(Choose two.)

A. Configuration register
B. NVRAM
C. Boot flash
D. CMOS
E. Flash

Answer: A, B
 
QUESTION NO: 2

You are troubleshooting a routing issue in the TestKing EIGRP network. In this
network, which statements are true about EIGRP successor routes? (Choose two)

A. Successor routes are flagged as "active" in the routing table
B. Successor routes are saved in the topology table to be used if the primary route fails
C. A successor route is used by EIGRP to forward traffic to a destination
D. A successful route may be backed up by a feasible successor route

Answer: C, D
 
QUESTION NO: 1

The TestKing network administrator has issued the "VTP password TESTKING"
command on a Cisco device. What is the purpose of this command?

A. It allows two VTP servers to exists in the same domain, each configured with different passwords
B. It is the password required when promoting a switch from VTP client mode to VTP server mode
C. It is used to access the VTP server to make changes to the VTP configuration
D. It is used to validate the sources of VTP advertisements sent between switches
E. None of the above

Answer: D
 
QUESTION NO: 2

You need subnet a TestKing network segment. How many subnetworks and hosts
are available per subnet if you apply a /28 mask to the 210.10.2.0 class C network?

A. 30 networks and 6 hosts.
B. 6 networks and 30 hosts.
C. 8 networks and 32 hosts.
D. 32 networks and 18 hosts.
E. 16 networks and 14 hosts.
F. None of the above

Answer: E
 
QUESTION NO: 13

TestKing is opening a new branch office. Assuming a subnet mask of 255.255.248.0, which three addresses are valid host IP addresses that could be used in this office?

(Choose three.)
A. 172.16.20.0
B. 172.16.24.0
C. 172.16.8.0
D. 172.16.16.0
E. 172.16.31.0
F. 172.16.9.0

Answer: A, E, F
 
QUESTION NO: 22

Non-contiguous networks can pose a problem for network reachability in certain
circumstances. Which of the following routing protocols have means of minimizing
the risk? (Select three choices)

A. RIP v1
B. RIP v2
C. EIGRP
D. IGRP
E. OSPF
F. VLSM

Answer: B, C, E
 
QUESTION NO: 8

Which one of the following protocols allows the information about the configuration
of a new VLAN to be distributed across entire switched network?

A. STP
B. VTP
C. EIGRP
D. SNMP
E. CDP
F. None of the above

Answer: B
 
 URL Pendek:

| JAKARTA | BANDUNG | PEKANBARU | SURABAYA | SEMARANG |

Back
Atas.